Fence Cleaning in Orlando, FL

Vinyl is the most common fence here and it cleans up dramatically, but it is a thin panel with hollow sections. It wants a solution and a low pressure rinse rather than force, which would flex or mark the panels and drive water into the posts.

Wood is the material most often ruined by pressure washing. Too much force raises the grain, cuts furry lines into the boards and leaves permanent wand marks that only show up once the fence dries. Wood gets low pressure and chemistry, worked with the grain, aiming to lift the growth and the gray without eating into the timber.

Aluminum and wrought iron style fencing is mostly frame and air. The work there is in the pickets, the rails and the joints where growth and oxidation sit, and it is more detail work than area work.

Growth is almost always worse on the shaded side, which is frequently the side you do not look at, and it will keep re seeding the side you do. Where access allows it we clean both faces of the run. Where a neighbor or a hedge blocks access, we clean what we can reach and tell you what we could not.

The bottom rail and the few inches above the ground carry the heaviest growth on any fence, because that is where irrigation, soil splash and mowing debris land. Post caps hold their own layer of mildew. Gates get attention at the hinge and latch side where buildup collects and where hands actually go.

A fence line is the shadiest, dampest strip on most lots. It usually has plantings or grass hard against it, it gets hit by irrigation on a schedule, and airflow through it is poor. Add year round warmth and humidity and there is no season where growth stops. Vinyl shows it as green and black streaks, wood shows it as a gray cast and dark blotching, aluminum shows it around the joints. Cleaning takes all three back, and pre treating the growth rather than blasting it is what keeps the run looking right for longer.